Switchbox and circuit for Lightsupport for Ender 3 & Ender 5
Description
Hello there, this switchbox ist only a small part of a project to light up your 3D-Printer. There are two switches and one button to controll the whole thing. One button is needed to switch on/off the normal LED-Strip in the grooves of the Ender 3. The other switch ist needed to switch on/off the RGB-Strip on the backside of the Ender 3. The button is directly connected to the Arduino Nano to navigate trough the colors of the RGB-Strip. All LED-Strips work with 5V so you need a DC to DC converter to transform the 24V from the Powersupply to the 5V for your LED`s and the Nano. Parts needed: -1 x Arduino Nano V3 -1 x DC to DC converter (Imax = 3A) -2 x 2-way toggleswitch (for mounting diameter = 5mm) -1 x small sensorbutton -1 x ballpoint pen spring -20 x WS2818 RGB-strip 144LED`s/m -ca. 64 x normal LED strip 30LED`s/m (width = 7mm) !!!Attention: if you want to use more than the amount of LED`S above, you have to check the current because you can cause damage to the converter or the LED`s!!! Circuit diagram comming soon
Statistics
Likes
0
Downloads
0