Pear Of Anguish
Description
Update 2021/02/19: Instead of the printed pullrod / thread, you may now use a screw M8x80 and ballhead_top.stl + ballhead_bottom.stl - just glue the screw into the ballhead parts, using cyanacrylate glue. Update 2020/05/31: Tunneled bigger base part v3, to allow for threading through of fastening materials Update 2020/05/21: Added winged locknut v3 per request - guys, I'm concerned, don't overdo it... _________ Another (in this case my personal) interpretation of the medieval torture device, nowadays used mainly for fun. Print in food-safe PETG. A dip coat for the pear quarters is recommended. Remove any sharp edges. If the thread does not work well for you, rework it with a thread cutter. It's M8. Metric. The pear parts are held together by an O-Ring (9x2mm, yes, it's metric) Tool 1 and Tool 2 may be used to operate the Pear, there is a choice of two lock nuts. Lock nut can be locked every 90deg. by a keyhole lock (Burg-Waechter ME/2 or similar keyhole locks, search aliexpress for "stealth lock") The _v3 parts have a different lock position for better accessibility. Make your choice. Furthermore, v3 has a Safety Stopper to prevent the pullrod from getting lost. Just glue it to the end of the v3 rod after assembly. After all, use responsibly, consensually and AT YOUR OWN RISK. Putting a condom over the pear may be considered for safety reasons. Make sure that the O-Ring won't fail :-)
Statistics
Likes
55
Downloads
0