Skyrim logo necklace
Description
### A skyrim logo necklace! Original model by: https://www.thingiverse.com/thing:3042456 I basically adapted it to a simple necklace, thicker, added proper support, an attachment point etc... ### Printing! I included my supported stl's as well as the sliced files for the anycubic photon S. ### My print settings: (in use in the pre-sliced file) Printer: Anycubic photon S What to print?: 4 double sided skyrim necklaces at once Time to print?: around 8 hours Layer height: 0.02 mm Quantity of resin used: around 20 mL Type of resin: Anycubic Eco plant-based resin (macaroon pink and blue) Printing temp: around 20C, the highest I could get at the time ###Washing, Curing I recommend removing the supports before curing. It's a bit more tedious with gloves and a mask, but they come off easier and there is less risk of damage. also recommending to cure underwater, just tried with the last batch and they came out great. ###Sanding I started with 100 grit, then 150, 250, 600 grit. Basically sand the supports marks until they are flat, then increase the grit to have a smooth finish. ###Painting I did two thin layers of black primer, then two layers of shiny chrome, short ### /!\ WARNING /!\ I left the first three ones I printed on my desk in the sun before painting and they started to warp after 2-3 days. so maybe avoid leaving them in the sun before painting. (or cure them more). ### Have fun :)
Statistics
Likes
27
Downloads
0