Ultrasabers 12MM Switch Bushing
Description
This is a 3d printed bushing to remount the Ultrasabers switch after it has been removed or to mount a 3rd party 12mm switch. Ultrasabers typically uses hot glue to mount their switches. Heat gently with a hair dryer or heat gun then gently pull the switch and switch bezel away from the hilt. Remove all leftover hot glue then use this bushing in its place. Some sanding might be required to get the bushing started into the hole. Line up the original bezel then press the bushing into the hole until it is flush with the top of the bezel surface. Then you can press the old or new switch into the bushing hole. Take care as needed not to scratch your bezel or hilt.
Statistics
Likes
3
Downloads
0