Dual RD6006 / RD6012 Bench Power Supply
Description
Dual power supply to replace my functional, but hard to read dual supply: https://www.thingiverse.com/thing:3466963 Uses the same 48v PSU as before, but this has two RD6006 programmable supplies rather than the old DPS units. You will need: 4 M3 x 25mm cap head screws 2 M3 x 16mm cap head screws & washers 4 M3 square nuts 2 M3 plain hex nuts You will also require 3 M4 x 10mm screws plus washers & 1 M3 x 6 screw to secure the PSU (If you use the same S-500-48 unit I did) EDIT 28/05/20 - RD Tech have just released the RD6012, a higher power version of the ‘06. The dimensions appear to be the same as the original, so they should fit fine with no mods. Of course, usual caveats apply... I don’t have one to physically check, so I’m going by the sizes given on the 6012 product page. (Thanks to Gunno for pointing the new units out). EDIT 16/05/20 - RD6012 confirmed to fit with no issues (thanks to Gunter on the prusa site for letting me know)
Statistics
Likes
9
Downloads
0