Wall-E body for Mbot
Description
A Wall-e body for mbot. Print 2x all arm parts. Will also need: - 96 Lego tank track parts #10144 - 2x 24t Lego gear wheels (or just print from Thingiverse) - 2x 40t Lego gear wheels (same) - 4x Lego axle to pin connector #3749/#6562 - 1x M2x5 self tapping screw (for rear neck screw hole) - 13x M2x10 self tapping screws - 6x M3x10 screws - 2x Mxx20 screws - 4x M3x25 screws & nylock nuts (for motors) Make sure the "starter" part is on the power switch before installing SideL. Otherwise life becomes difficult. Enjoy!
Statistics
Likes
6
Downloads
0