HEVO extruder mount for UBIS hotends
Description
A modified extruder mount for HEVO https://www.thingiverse.com/thing:2254103 to use UBIS hotends, from old ceramic ones to the newer UBIS 13S all-metal. I provide also a cut version of the extruder mount to test print settings. The sizes were matched to the original UBIS dimensions. As explained by the seller: --- The dimensions for the grove on the Ubis13 hot end is best described as follows: (All dimensions are in inches) The grove is centered down from the top by 0.200" The wide part of the grove is 0.160" (about the center at 0.200") The narrow section, the deep cut is 0.060" wide (about the center at 0.200") with a diameter of 0.455" This makes the slopes on each side 0.050" wide. The OD of the hot end is 0.625" which as it turns out is very close (15.88mm) to the 16mm on the E3D hot end, so it should fit just fine. --- The latest UBIS 13S offer E3D mount so this won't be necessary anymore.
Statistics
Likes
0
Downloads
0