Hero Me Gen4 for the last CR-10S PRO release (V1, not V2)
Description
I encoutered a problem, because Creality has reduced the size of the plate on the left with the last release of the CR-10S PRO (I don't speak about the V2 from TM3D with the BLTouch already installed). Check out the photo here: https://www.thingiverse.com/make:753190 And my photo: https://cdn.thingiverse.com/assets/4f/4e/b1/a2/1b/IMG_20200512_144649_-_CR10s_pro_original_vs_upgraded.jpg Ty can see more details here: https://www.thingiverse.com/make:803681 I had to cut the rounding on the left of the support because the metal tab of the X limit switch comes into contact with the plate and not the tab of the support. I now have a problem: I received my 5015 fans and I wanted to put the one on the left. So I have to use the support for BLTouch 1 or 2 (to put it more to the left), and if I do that, the BLTouch will hit the left X engine. I resolved by : - Hero_Me_Gen4_CR-10S_Pro_Upgraded_Base.stl : Either enlarge the tab of the support to the left to make it the size of the turntable of a CR-10S Pro old model, and make a deep return so that it is this part which comes into contact with the metal tab of the sensor, I also enlarge the hothend screws holes, so it be easier to fix it how. - BLTouch_Bracket_One_CR10s_Pro_Upgraded.stl : Extension of the BLTouch support to put it further forward to avoid it touching the left engine of the X (I think it should be oblique to pass between the left duct fan and the engine). This part is to be used with the 2 kight fan ducts. - griffe bltouch 60.stl : Another BLTouch bracket, to be used with the dual fan duct with one 5015 (with an 60° angle) Hope is helps.
Statistics
Likes
2
Downloads
0