Schacht Bobbin for Matchless, Sidekick, Ladybug
Description
There are already several Schacht bobbins on Thingiverse. But for some reason, my printer is struggling to print threads. And I don't like gluing. I made a system where the discs and the tube don't have to be glued together or connected with a screw thread, but with clips. The tube is printed upright. For a better connection to the print bed, the bottom is almost closed except for a small hole. This is only a layer of 0.2 mm, but it gives a better adhesion for when the print gets higher. Of course, this must be removed afterwards. And probably the holes for the shaft also need to be drilled a little bit (8 mm) to fit the flyer. Everything can be printed without support.
Statistics
Likes
4
Downloads
0