CR10S PRO v2. Fan Duct
Description
I liked the original by McLareniak however I found the arms holding it to the fan to be a little brittle and easy to snap off, and also allowed the duct to droop a little when printing. This is made from the v3 from McLareniak, the only modification I have made is to add some structural braces to these arms, to make them a little stronger and more rigid. It can still be printed with no supports. Full credit to the original author as I have hardly altered this but felt I should share it in case others have similar issues. I printed this with Sunlu Red Copper PLA, as I didn't have any PETG/ABS the part seems to be holding up quite well, have had a couple of 48 hour prints and no issues as yet. I have also not had to move or modify the BL Touch sensor, I just printed it and bolted it on. I don't expect anything in return for the objects I share but if it has helped you and you wish to thank me, feel free to buy me a coffee: https://www.buymeacoffee.com/plasmasoft
Statistics
Likes
56
Downloads
0