UV-5R Wall Mount and charger Mini (Remix)
Description
Remix of https://www.thingiverse.com/thing:3387065 I wanted to print a few of these so I made some changes to save plastic. I also made changes so it prints well without supports. I would still recommend a brim although it's not necessary if bed adhesion is good enough. To setup the charge circuit, use something like a USB 2S 7.4V Li-ion charger module and thread wires through the holes in this model. I also added a diode in series to drop the voltage to 6.8v, which means the battery will degrade less over time. Changes made: * Made the model shorter for faster printing & use less plastic * Changed to shape to allow printing without supports * Aligned screw holes (the bottom hole in the 3d model was out of alignment)
Statistics
Likes
21
Downloads
0