Stand for Huntress Mask by jdogid
Description
This is a stand to hold the awesome huntress model by jdogid. It's a two piece, the back stand which fits into the ears of the mask and a small bottom piece for the chin of the mask to rest in. It's built for a mask that was scaled to 125% so you will need to scale it for your own size. The main stand itself is in two pieces since it's tall. I glued them together. You can put them together in a slicer yourself and print as one unit, but I did it as two pieces. You'll notice the front support is a little tight because of a small overhang on the rear edge of the hole where the mask fits. I printed it at 103% size and then used a blade to take some of that overhang away.
Statistics
Likes
2
Downloads
0