Kamado Joe Classic replacement handle

Kamado Joe Classic replacement handle

Description

Replacement handle for the Kamado Joe Classic bbq/smoker. Mine was bamboo and it degraded over time. Initially I made a like for like replacement but realised I could make a neater solution than the stock one. This slides straight over the metal mounting loop and fixs in place with the same hardware the stock one used. I used ABS as it will be in the sun and PLA would likely degrade. Nylon may be better being a bit less brittle. No fancy print settings are needed, no need for a raft, brim, supports or anything. It is the same size as stock so will likely need to be printed on an angle depending on your print bed size.

Statistics

Likes

0

Downloads

0