FT-6 Dual Extruder 7530 Radial Fan Mounting Kit
Description
Parts cooler I made for my FT-6 (dual extruder). May work on the single extruder variant as well. The duct should just snap onto the fan. If you feel it is too loose or tight, adjust scale by a few percent (1-3%) in your slicer to accommodate. Height is adjustable by installing the 7530 fan higher or lower as desired. **Make sure you calibrate your PID settings after installing! Bring the bed up to the nozzle, turn on the fan, then start your PID calibration to avoid thermal runaway errors**
Statistics
Likes
1
Downloads
0