Ender 3 Pro LCD Case (With Lid)
Description
Do you 3D print in your room like I do? Then chances are you print while you sleep. So i'll bet the LCD screen keeps you up from being too bright. I have the solution. I have Printed a replacement case for the stock circuit board that mount with original hardware. Also there's a lid to close when not in use. The case has a very snug fit for the circuit board but should be no problem going in. The four screws should line up correctly but be careful when screwing in. I suggest screw in slowly half way then back out and the slowly re-screw into the plastic. Do not over tighten. The lid has two options. Option 1: Pin through hinge (open holes where you slide a pin through the holes from the top like a door hinge). Option 2: Ball snap design where the lid hinge has two balls that snap onto the LCD case. This method I wouldn't recommend because it dents up the LCD case but also less parts to print. It works but sucks popping on. If printing white like i did - 100% infill. If any other color then nothing less than 50%. I've included multiple pins with various sizes for pin through design. Enjoy and any criticism is welcome.
Statistics
Likes
7
Downloads
0