Easy Mount Fang CR-10, Ender Stock Fan
Description
Really like Tacblades high clearance fang for the CR10 but wanted something that could be installed and removed easier without unmounting the hot end. This version mounts to lower hole of stock fan shroud instead of heat sink screws. Allows access to hotend with only one screw. This is a rough mod with the following changes: - Add bracket for lower left fan shroud mounting hole. - Remove center heat sink mounting supports. - Trim heat sink side clips for easier installation. - Use oblong mounting hole to allow slight adjustment of fang height. I use this on a CR10 and CR8. May work with other printers. Check my things for a 5015 fan version.
Statistics
Likes
5
Downloads
0