Easy Mount Fang CR-10, Ender 5015 Fan
Description
Remix of GaminGits 5015 fan mod for the CR10. This version mounts to lower hole of stock fan shroud instead of heat sink screws. It can be installed and removed easier without unmounting the hotend. Allows access to hotend with only one screw. This is a rough mod with the following changes: - Add bracket for lower left fan shroud mounting hole. - Remove center heat sink mounting supports. - Trim heat sink side clips for easier installation. - Use oblong mounting hole to allow slight adjustment of fang height. I use this on a CR10 and CR8. May work with other printers. Check my things for a stock fan version.
Statistics
Likes
12
Downloads
0