Gen 4 and 3 Dual 5015 Ducts Combined
Description
Media Man has done a fantastic job with the Hero Me cooling ducts with each iteration. However, the latest generation has a couple of problems and its development seems to have slowed down. To be honest, the single 5015 ducts probably do an adequate cooling job. However, I fitted the Dual 5015 Ducts because it means I can run them at 50-70% which means the printer is far quieter. Additionally, you have that extra cooling capacity available for large overhangs and more complex prints. This is my combination of Generations 3 and 4 of the Dual 5015 Ducts. Media Man uses TinkerCad a lot, it's not a program I enjoy because of it's limited functionality, hence I have some jagged edges that I should probably correct in MeshMixer if I really wanted to.
Statistics
Likes
7
Downloads
0