JGAURORA A3S Modeling platform easy leveling mount kit
Description
I think JGAURORA A3S is very nice but that has a few issues for me. I wanted to solve was the difficulty of turning the knobs that adjust the height of the modeling stage. It's painful for my fingertips, and the knob on the back right side where the filament reel is located is hard to turn... So I made parts by A3S and updated A3S to solve this issue. This updated A3S is working fine so far, and the printing results are good, but I'd like to try various printing models for a while longer. If I don't like the results, I will put the A3S back in its original style. If you want to print... <Upper Left.stl> - Printed as is : 1 - Inverted and printed : 2 <Upper Parts(with Cable guide).stl> - Printed as is : 1 <Bottom parts.stl> - Printed as is : 2 - Inverted and printed : 2 and, In order to install these, you will need the following screws and others. <for Upper parts> M3 15mm - Countersunk screws : 4 - Nuts : 4 - Washer : 4 <for Bottom parts> M4 40mm - Hexagon bolt screws : 4 - Nuts : 4 - Washers : 8 **The four springs divert the original ones. M3 20mm Standard screws : 4 Nuts : 4 Washers : 8
Statistics
Likes
6
Downloads
0