Emmani ring holder
Description
Total of 15 plus different items designed to be printed as multiples and joined together like a jigsaw, I have created a few different sizes for different applications 1x1, 2x1 3x1 4x1 2x2 All can be joined together in any combination to fill a drawer or shelf etc.. Using a dovetail joint these cases can be attached to each other with the lids they can be stacked on top of each other. Using lids can be used as individual travel boxes to prevent chains from getting tangled or rings getting damaged or earrings getting lost. The ring box is also designed to store earrings underneath. The engraving on the side will help to point out the direction to open. The ring display is designed to prevent rings from spinning to allow them to be presented at a nice viewing angle After the print, the parts need a little deburring but the parts I tested and used needed no rafts or supports. I designed this on my time off over a day so if it's not perfect please forgive me :) PS the ring holder needs to be turned 90 degrees on the print bed. This will mean the pin for the center of the ring will be pointing up.
Statistics
Likes
4
Downloads
0