My K-cup coffee filter shaper
Description
This die perfectly shapes standard filter papers to fit My K-cup. The mesh screen in the my K-cup filter is pretty fine but performance benefits greatly from an additional paper filter. 1. Place the filter paper between the two halves of the die and gently press the upper half into the lower. Be careful as too much force can tear out the bottom of the filter. It's beneficial to remove and insert the upper half a couple of times during the process to release the tension on the paper as you seat it fully. 2. Tear the excess filter paper toward the centre of the die to remove it. The teeth will assist in cutting it. 3. The filter is perfectly formed and sized. 4. ...but wait a minute, it's a lot easier to fill if you leave the paper assembled in the die. Load it with you favourite ground coffee 5. Now remove the top half of the die and the coffee will fall through the hole at the bottom to be left behind in the filter paper. 6. Gently remove the paper containing the coffee and place it into the My K-Kup filter container. 7. Assemble into the My K-Cup. 8 Brew and enjoy!
Statistics
Likes
5
Downloads
0