Ramps and Arduino Mega enclosure for 3030 v-slot
Description
Enclosure for Ramps 1.4 and Arduino Mega 2650. Attaches to 3030 V-slot with 5mm bolts and slide nuts, all other hardware is 3 mm (12 bolts, 9-12 nuts). The variation in the number of nuts is due to variation between printers used. Mounting holes for arduino/ramps are small enough to direct screw into, but if you over tighten and strip the threads you may need to use nuts to retain the ramps/arduino boards. Cut outs top and bottom for cable entry, at the top for LCD cables and for the USB cable to allow easy updates to firmware. Lettering for cover can be printed in a second color and then pressed into place for a smoother look. Cut out for 40mm fan on the cover, but there is also a part included called blower_fan_plate.stl. This allows a blower fan to be used for higher airflow over the stepper drivers.
Statistics
Likes
0
Downloads
0