Watergun Repair Kit
Description
One of my twin girls' new watergun crashed during the last hot days and there were two bank holidays ahead so I had to immediately repair it as all shops were already closed. The water nose fell off and part of is was broken as well and the other end I had to remove as the sealing ring inside lost it's position as well. Sad quality for a first day use - but challenge accepted :-). I removed the former plastics, cut down short part of the pipe and designed fitting, more massive adapters. These are simply put together and then glued to the pipe as well as to each other. My girls are 4.5 years old and this setup still lasts until today and we had no blockers in our waterfights during the free days anymore :-). Print with common settings. I used default silver/grey Prusa PLA with 0.2mm and 30% fill.
Statistics
Likes
1
Downloads
0