Winchester Razor Slim Earmuff replacement clips
Description
This part is based on my replacement clip for 3M Peltor earmuffs https://www.thingiverse.com/thing:4432280. Recommend it to print on 0.2mm or lower and in PETG. Depending on your printer, the part might need reboring of the holes. Try to clip it with mild force, if the earmuff does not go in, rebore the hole in 0,5 mm increments starting from 5mm. The wire hole is actually a keyhole and requires proper alignment with the pressed part of the wire to install. this keyhole might need reboring too, but leave it snug.
Statistics
Likes
2
Downloads
0