Replacement Clip for 3m Peltor Earmuff
Description
I made this as a replacement clip for 3M Peltor earmuffs. It should be compatible with all the common earmuffs and also their electronic sordins like Peltor Tactical series and Comtacs. Recommend it to print on 0.2mm or lower and in PETG. There is a layer i left solid so you dont need any supports. You should print the part with this layer horizontal and looking down. It can be easily cut out with a utility knife. the pictures are self explanatory. Depending on your printer, the part might need reboring of the holes. Try to clip it with mild force, if the earmuff does not go in, rebore the hole in 0,5 mm increments starting from 5mm. The wire hole is actually a keyhole and requires proper alignment with the pressed part of the wire to install. This keyhole might need reboring too, but leave it snug or your earmuff will drop.
Statistics
Likes
4
Downloads
0