ESP32s NodeMCU v1.1 Case
Description
For NodeMCU ESP32s, mine says v1.1 on the back. I'm sure it works for other models as well. 3 files, one top, one bottom and one bottom with magnet holes. Most importantly, there is a hall effect sensor under the metal plate that I want to take full advantage of. Its not protruding but flush with the rest of the case. https://www.amazon.ca/KeeYees-Development-Bluetooth-Microcontroller-ESP-WROOM-32/dp/B07QCP2451/ Printed in a rush at 4am. first iteration showed me that I needed to extended the lid height by 1mm, shift the light holes to the center 0.5mm, shift the square hole up 1mm and add a chamfer to the buttons. Second iteration was good and I added some magnets because I feel like a wireless device needs magnets to just stick anywhere. Hope it works out for everyone.
Statistics
Likes
12
Downloads
0