Stand for Magic Keyboard / Magic Trackpad (1 location)
Description
# Why I created support? I wanted to be able to put my Magic Keyboard vertically on a support but I could not find any model, this in order to make room on my desk to be able to use the most space to be able to work. So I created my own support and I hope you like my work # Publish I would be delighted if you took pictures of the impression of my work. # PRINT CONFIGURATION **I did a print test with a filling of 70% and it was good, but I advise you for an optimal result to make a filling of 90% or even 100%** **For the layer height** I advise you to make **0.15mm** but 0.20mm should be good too, it will depend on your desire to have a logo and smooth border or not # YOU ARE LOOKING FOR A MODEL WITH TWO LOCATIONS ? You can find other version with two locations [here](https://www.thingiverse.com/thing:4440870) # Changes **07/06/2020** - Add logo on second walls **09/06/2020** - Center Logo - Add version : Round edge 5mm - Add version : Round edge 10mm - Add version : Round edge 5mm with no wall edge rounds - Add version : Round edge 10mm with no wall edge rounds - Add version : Without any edge
Statistics
Likes
14
Downloads
0