Vacuum Cleaner Handle and Laser Tower Cap Vorwerk VR200
Description
This is a replacement handle for the Vorwerk vacuum cleaner VR 200. The handle from our cleaner broke just after the joints. (From my point of view a design mistake. The plastic is way too thin to hold the weight of the cleaner.) I tried to fix it with glue and a reinforcing piece of metal. But then it did not fit any more flat into the designated area. This then caused problems for the laser tower and an error message was displayed that I should clean the device. I had to split the handle into two part because of the limitations of my printer. I could print it upwards facing in one piece, but the layering is in the main force plane and it broke immediately.
Statistics
Likes
3
Downloads
0