Ender 3 Pro Tool Holder inc. Caliper
Description
Remix of Ender 3 Tool Holder by CDeviant: v1.4.1: + Added extra materiel at the rear (more junk in the trunk) for an additional tool slot + Added additional slot to store vernier calipers + Moved small wrench slot and screwdriver slots to accommodate the caliper slot + Opened up the scraper slot, as i found it could be tight + Opened up the needle slot, as that was a bit tight too v1.4.2: + Refined the back edge + Added 9mm hole for 'X-ACTO' craft knife storage Follow the original print advice: For best results, it should be printed 45 degrees from the bed. Model is already positioned this way Enable support / 80% support overhang angle / support placement - touching build plate only / Enable support brim Print with a part brim
Statistics
Likes
10
Downloads
0