Atari 2600 Wireless Controller Battery Door
Description
After purchasing a set of these controllers with only one battery door, I decided to design a replacement part for those who need it. The measurements were taken straight from the original, though don't expect it to be as flush as a factory-original cover :-). (The cover pictured in the photos was the first version, and I have since then adjusted a couple dimensions a little bit to make it slightly more of a tight fit.) Also, for reference, this was printed on an Ender 3 Pro, and sliced in Cura in dynamic mode. Supports are only needed for the latch.
Statistics
Likes
1
Downloads
0