Twisted LM8UU bushing for i3 Mega
Description
Thanks to "Loughkb" for original (also remixed) design It really made my i3 Mega less noisy. I sadly discovered that the lubricant wouldn't spread out evenly and so I just gave the bushing a small twist to force the lube to move every time it slides across and thereby get a better coating on the 8mm rod. After printing you will need to sand/grind down a little on the inside to fit your particular printer, takes a few seconds and tries to get it just right (to tight of a fit and your motors will struggle and might even skip) but it really is worth the effort to get rid of the pre-mounted maracas bearings. - For less friction on bedplate (uses 3 bearings from stock) you can split it in 20mm chunks.
Statistics
Likes
5
Downloads
0