Tyro69 legs - base and battery cover
Description
Edit (6/20/2020): After several flights, I have made the legs a bit sturdier, and added holes in them to route the antenna wires through. It is "BattCvrLegs_V5" in the files. The original design is still available, as well. ~~~~~~~~~~~~~~~~~ This is a remix of some great parts. I added some legs to the battery protector, to make it easier for us to take off on a grassy field - it holds it level and keeps the blades out of the grass. I also shortened the receiver-holder, which was originally designed to fit in the stack on top. I cut off its legs so I could superglue it to the bottom of the base. We used some masking tape to help direct the antenna out each side, at least for now. It fits loosely, and will only go in/out of one side - pull the cable through until the circuit board is in place. You should be able to pull it forward to access the bind-button, as needed. Make sure you check the length of your cables before gluing it in place. I printed at a .24 layer height, just for reference. No supports are needed.
Statistics
Likes
0
Downloads
0