SHARK KEYCHAIN

SHARK KEYCHAIN

Description

This is simply a Remake to add a key ring to an already amazing design. This shark prints in one piece and as soon as you remove it from the bed he has full range of motion. The tail spins 360 degrees, the fins move and the mouth opens and closes. Only caveat is when I printed my few prints at .1 layer height the teeth required 30 sec. of x-acto blade work to get them to separate. They may not do this on other printers, slicers or even just a layer height change. There is ample room in the key ring loop so the print can be scaled down and it still be strong and large enough to use. ENJOY! !!!ATTENTION!!! -Ignore the holes in the tail in the clip showing the mouth movement. This was rectified in the published STL file.-

Statistics

Likes

51

Downloads

0

Category

Keychains