Instone Inventor Pro Spool Holder remixed
Description
This spool holder fits Zyltech spools pretty well. It also fits inside of an Instone Inventory Pro. The holder just clears the build plate by a few mm. This will be updated over time so check back if you are going to reprint anyway. The rod will need to have full supports. It would be great if someone could make a version of the rod that screws together. I just don't have the patience or skills for printed screw parts. Update list: *Smoothed out or beveled corners *Beefed up side verticals *Larger hollow rod *Shorter Rod to better clear the bed This is a remix of another design on Thingiverse. I can not find the design, if this design is close to yours then let me know and I will add credits where credits are due. However, I found it a little too wide and would stop the build plate from dropping. It may not have been too wide but it was a little flimsy so that may be how it got under the build plate.
Statistics
Likes
2
Downloads
0