Tamiya Stadium Blitzer / Futaba FXT Rear Hub Carrier
Description
Rear hub carrier for the Tamiya Stadium Blitzer / Futaba FXT. This is designed with zero degrees of toe-in. I may make a version that adds 1 degree; but I have not found a need for general use on the FXT or SB. I designed this originally for printing on a M3D printer and was able to get it to print - but this is a retuned version for all other printers. This is a bit chunky; more an artifact of getting something that the M3D could print, but I may go in and clean this up at some point. The hinge mount should be reamed with a 3 mm drill bit and the mounting provision is setup to use M3 screws.
Statistics
Likes
2
Downloads
0