20x20mm Test Cube!
Description
Hello! Here i have designed a simple test cube which can be used to calibrate your extruder and/or axis E-Steps! It can be printed using less filament than some other test cubes - The outer dimensions of the object are 20mm x 20mm x 20mm (L x W x H) - Actual printed thickness of the walls should be 1mm as what corresponds to the 3D object. 1mm is approximately the thickness of two walls for a .4mm nozzle. - As mentioned above, please use two walls for printing this to check wall adhesion * The following formula can be applied to both flow rate and E-STEP calibration * Calculations for calibration are as follows: [(intended length)/(measured dimension)] x Current Value = New Value
Statistics
Likes
5
Downloads
0