
pregnant planter (NSFW)
Description
Thanks to JanszaP for the torso. I created this pregnant planter. Scale it to the size you need and check the thickness of the walls before printing. The inner is not designed very well - but who cares. There is'nt a drainage. There are two versions. Both need support in the current orientation, but if you print it up-side-down you will only have to use support in the inner (but more) and get a clean outside. I did not print it yet and made it just for fun. If you made it, please post it. Published on Thingiverse #4463811 ---- You do'nt like the wall thickness? It should be possible (but not tested with this thing!) to print it in a mode - a bit like vasemode - hollow with a given wall count (but not really usefull for up-side-down except you use a wide brim and change the values for top/bottom-layers) For cura use this settings: - Remove all Holes -> yes - Top Layers -> 0 - Bottom Layers -> I guess min. 4 - Wall-Count -> I guess min. 4 - Infill -> 0 - Support -> your favorite
Statistics
Likes
7
Downloads
0