Freewing Avanti S 80mm main landing gear reinforcement
Description
I am a very happy Avanti owner. The plane flies nice, sounds nice, and forgives a lot of mistakes. However, main landing gear, while robust, tend to break from the foam joint on harsh landings, since nothing but that recieves the impact if the front gear hits the ground. This can be fixed giving the front landing gear a proper support to help absorb minor to medium impacts. Check photos for installation, just glue it with regular (foam-friendly) CA Can be printed on PLA or PETG, I recommend the latter if possible due to added elasticity and longer lifespan under sunlight or humid conditions. Use arround 20-30% infill for a nice <5g part There are many other nice parts like this from other authors, so feel free to check which one fits your needs. I did not like any of them because they seemed either weak on the spot receiveng the impact like this one: https://www.thingiverse.com/thing:2627712 , or just uses a lot of material unless printed with low infill, like this one: https://www.thingiverse.com/thing:2553111
Statistics
Likes
3
Downloads
0