Tesla Hood Ornament - For Joke "I Identify As A Tesla"
Description
I made this for my car which says "I Identify As A Tesla" on the bumper as a joke. If you are using an Ender 3, you can just use the included .gcode file and it'll print properly. If not, reduce size to 50% and set wall thickness for top/bottom and sides to 5 or more. Also, be sure to print with supports at 15 degrees. If you try to do it without the supports, the mounting plate will fall over half way though the print. For the two screw holes in the back you can use 5M*20 screws (or longer. 20 was all i had on hand, so I drilled a bit into the PLA until it was flush). The one in the front you need to use a 4M*20 screw for because I was dumb and put the screw hole too close to the part holding the "T". Be sure to send me pics if you make this! Really want to see them! :)
Statistics
Likes
14
Downloads
0