Under Cupboard Stemmed Glass Rack
Description
Had a specific requirement for a under shelf glass rack - so designed this. Design is 18cm long and has a straight run at the end that you can either leave to connect 2 together (for a deep cupboard), leave if its at the back of a cupboard (so nothing slips off) or snip off to access from either side. No screw holes have been put in it - this was intentional so that I could put them in the best place for my shelf. Plastic is thin enough to screw straight through, drill through or if you're feeling brave and using command strips will hopefully stick well! (i really wouldn't use command strips if its holding glass!) Under Cupbpard Stemmed Glass Rack (desman83) - 19/06/2020 Under Cupboard Stemmed Glass Rack.stl Printer: Creality Ender 3 Rafts: No Supports: No Resoltuion: 0.2 Infill: 100% Filament: Amazon Basic 1.75 Filament Colour: Transparent Filament Material: PETG, although PLA would be fine Designed With: TinkerCad Sliced in: Ultimaker Cura 3d Tip me? Thanks! BTC Wallet: 1LDVHtDPcELFKr2Z6ygADbXAGNjCerTUNV
Statistics
Likes
10
Downloads
0