Ender 3/Ender 3 Pro Minimalist Z Cables Support and Guide
Description
Minimalist support post and cable guide to hold the ribbon and hotend cables in order to avoid cables snagging. This design holds and hides as much cable as possible keeping full Z axis movement without skimming over any part. This design is inspired by the previous Daz68'cable support design: https://www.thingiverse.com/thing:4261674 The cable clip is inspired by the nastyninjabear' design: https://www.thingiverse.com/thing:3379570/apps Note that you need two short M4 fasteners to install the pillar. I used the leftover T-nuts and bolts of the Ender 3 Pro mounting. Also, you should divide the ribbon cable into two parts (E motor and X motor/sensor) to have a narrower cable. Put them one on top of the other inside the pipeline.
Statistics
Likes
17
Downloads
0