Resin Support Bin with Brush Top
Description
INSTRUCTIONS BRUSH -Must be printed in FDM. -The brush file should be printed with its back side down(the file should be oriented this way already). -Check the layerview and confirm that the grass is actually going to print and that supports are not being created between the grass strands -Once printed carefully cut the grass from the end that attaches to the thin wall end. Then cut the thin wall from the rest of the print to reveal the brush. BIN -its a bin, just print it. Things Story The space i have to work with my resin printer is limited and not suited to making a mess while removing supports. I needed something i could dump the supports into as I'm cutting them off the model. Because i do most of my resin support removal while the model is still wet with IPA, the tiny bits of support can easily stick to gloves or the model. With this design supports can be tossed into the bin and any tiny bits that want to hang out on your gloves or side cutters can be brushed off with Superbeasti's 3d printable grass. *Dont Print with supports* But if you want to anyway, set it to 'Support touching buildplate only' otherwise the grass will print as a brick...
Statistics
Likes
1
Downloads
0