Generic Beitian BN-880 mount to zip-tie it on top of uav
Description
## About I had a look around, and I didn't really find a solution that i liked much, so I designed my own. there is two channels for small zip-ties in the bottom, and its angled about 20 degrees to the back, so a forward flying drone should have it face upward. I've test printed it in PET-G and final-printed it in TPU, both variants held my BN-880 just fine (i had to cut it out of the PET-G one, so i could put it in the TPU one. If this is useful to you, please leave a make-picture :) ## Printing it I've been printing it on the side with tree supports. TPU is recommended.
Statistics
Likes
10
Downloads
0