CR10 V2 Filament Sensor Spacer
Description
This is the spacer to align the filament sensor with the Bondtech BMG extruder. I am using a clone, which works great but it did not come with the spacer needed so I had to design one. I made two version. One for the threaded inserts and the other without. They both work fine but now you have options. Installation Instructions: https://bit.ly/2NhFLgw Required: 4 - M3x6mm screws (M3x8mm will work too) https://amz.run/3KHf Optional: 4 - M3x6x5mm threaded inserts https://amz.run/3KHd IMPORTANT: If you decide to get the clone make sure you get the left mirror version https://amz.run/3KHY
Statistics
Likes
17
Downloads
0