Wharfedale dx2 speaker mounts
Description
Wharfdale dx2 front and rear speaker mounts, when splicing you can mirror front/rear mount to give left and right mounts. I have also included a wall cover, complete with screw cover inserts, to hide any excess speaker cable. This is designed to be used in conjunction with trunking used to run speaker cable. Again this can be mirrored in cura for left/right sides Rear are set at 110 degree angle, front are set at 35 degree. (I know this should be ideally 30 degrees but was optimum for my room size, can upload 30 degree ones on request) Designed using tinkercad Printer Ender 3x Infill 20% Support Tree Print speed 100 Print quality Low (0.28) Slicer Cura Material PLA
Statistics
Likes
0
Downloads
0