EZR Extruder - Cable Guide
Description
After installing my EZRstruder by SeeMeCNC, I wanted a small cable routing part to be installed on the front of the extruder using the preexisting screw holes. Here is what I made! Please see images for installation and print setup. *All hardware used, other than zip tie, came with the EZR extruder.* That said, here is the hardware used just in case: 2x M4 by 20mm 2x M4 Lock Nuts (Normal M4 nuts would work too) 1x Zip Tie (2.6mm x 1mm) *optional, but recommended.* I hope this is useful!
Statistics
Likes
2
Downloads
0