Toothbrush Stand for Gloridea electric toothbrush
Description
This is a toothbrush stand for a cheap electric toothbrush I got from Amazon with the brand "Gloridea". It might fit Fairywill toothbrushes, as they look very similar, but I don't have one to check with. There are pegs to stand 3 heads. I've left an open hole in the bottom of the toothbrush section to allow moisture drainage, but there is a lip so the toothbrush is still held off the surface. I created this by drawing around the toothbrush, scanning, converting to SVG and cleaning it up before importing into Tinkercad. The profile isn't exactly accurate, but it does follow the curves of the toothbrush body to a reasonable degree. There's a bit of wiggle-room around the toothbrush body, as I wanted it to be a balance between a close fit and easy to drop the toothbrush into the hole. If you wanted it tighter, you could scale this down a tiny amount, but this could affect the pegs for the heads.
Statistics
Likes
3
Downloads
0