Lulzbot Taz Workhorse PanelDue LCD mount
Description
I did a Duet swap on my Taz Workhorse. I hadn't planned on using a PanelDue, but I hated the way the original LCD screen cutout looked when I blanked it. Not sure if this will fit any other Lulzbot printers. My cutout dimensions are 80.65mm x 53.15mm. I designed this to snap in the cutout and let you use the rest of the PanelDue case from LumberjackEngineering. https://www.thingiverse.com/thing:2799628 There is plenty of room for cables to the PanelDue. The pivot mount screws into the snap in mount. 4 M3 screws, nuts, and washers. Length should be at least 10mm. The snap in is pretty snug. This will not leave you enough space for your enclosure if you use one. I apologize, I'll rework it if I ever decide to use my enclosure again. My pictures show the PanelDue 5I installed on the Taz Workhorse. I didn't think to take a picture before I screwed it together. It's pretty self explanatory though.
Statistics
Likes
0
Downloads
0