Iflight IX_v3.1 Caddx Vista mounting solution
Description
Caddx Vista Mounting Solution for Iflight IX3 v3.1. First I started from "rinciong" design : https://www.thingiverse.com/thing:4153694 But finally I only keep the camera position and the Idea of using M2 insert. So thank you "rinciong" for your great design. There is two mounting solution for the Caddx Vista Antenna. One use the plastic mount coming with the antenna. But I prefer the one using a TieWrap. At the end it old stronger the antenna. The RX and Fullspeed LuckyBox mounts are modulars. So you print only what you need. The 20x20mm various mounts should allow you to mount various FC/ESC with the Caddx Vista. But if your Gyro is very sensible I recommend you to use Silicone rubber instead. The Screws going trough all component make the frame very rigid and it can take a lot of beat-up. I add in the kit a 20x20mm Back Fin. Work well for Turttle Mode. You will need 4 M2 x 3mm Brass Cylinder Insert. Look on amazon. They are nor Expensive. You will also need 4 M2 x 40mm screws. 35mm could work if you don't put the BackFin. If there any problems please contact me.
Statistics
Likes
6
Downloads
0