LED strip holder with wire management for all CR10/CR10 V2 variants
Description
A remix of Kondrez's [LED light bar](https://www.thingiverse.com/thing:2802457) to allow for neater wire management via the additional channels on the back/extension of the right-hand arm. Designed for two 22AWG wires (+/-} to sit snugly in the channel, and be directed down to the 2040 extrusion for routing to the printer's PSU. Requires two M3 bolts and two 2 nuts for securing to the 2040 extrusion. <b>Print with supports</b> - they are very easily removed from the recess. It should bridge fine without supports but do so at your own risk as wires may not sit flat in the recess due to sagging of the bridged section. <u>A reminder to use the appropriate gauge wire for the voltage/amps needed by your LED strip.<u>
Statistics
Likes
6
Downloads
0